Which of the following is NOT a classical plume type?
Answer: B
Correct answer: Downwashing
The classical plume types are named for the stability profile that produces them: looping, coning, fanning, lofting, fumigation and trapping. Downwash is not among them - it is an aerodynamic effect of the stack or a nearby building, and can occur in any stability class.
Please log in or register to report this question.
Which statement about tall stacks is FALSE?
Answer: C
Correct answer: They reduce the mass of pollutant emitted
That is the false statement. A tall stack changes where the pollutant arrives, not how much leaves. The other three are true: it lowers the maximum ground-level concentration, moves that maximum further downwind, and is for exactly this reason given only limited credit by regulators.
Please log in or register to report this question.
Which change would NOT reduce the risk of stack tip downwash?
Answer: D
Correct answer: Widening the stack at constant volumetric flow
Widening the stack lowers the exit velocity, since \(v = Q/A\) - which makes downwash more likely, not less. The other three all raise the velocity relative to the wind: increasing it directly, narrowing the bore, or concentrating the flow into fewer flues.
Please log in or register to report this question.
Which of these is NOT a reason to reheat flue gas after a wet scrubber?
Answer: A
Correct answer: To reduce the mass of pollutant emitted
Reheat does nothing whatever to the mass emitted - it only warms the gas. Its three genuine purposes are all listed: to lift the gas above its acid dew point, to protect the lining from the acid that would otherwise condense, and to restore the buoyancy the scrubber removed.
Please log in or register to report this question.
An operator proposes a wider stack to reduce fan power. This is
Answer: B
Correct answer: Risky, since the lower exit velocity invites downwash
At constant flow a wider stack means a lower exit velocity. Once that falls below about 1.5 times the wind speed the plume is drawn into the stack’s wake, effective height collapses, and ground-level concentrations rise - a poor exchange for the fan power saved.
Please log in or register to report this question.
Which statement about the good engineering practice height is TRUE?
Answer: C
Correct answer: It places the release above the wake cavity
The GEP height is the height at which the release clears the recirculating wake generated by nearby buildings. It guarantees nothing about ambient standards, it is calculated from building dimensions rather than emissions, and it is not a maximum permitted height - it is a ceiling on the dispersion credit that may be claimed, which is a different thing.
Please log in or register to report this question.
Which of the following would NOT increase plume rise?
Answer: D
Correct answer: Cooling the flue gas before it leaves
Plume rise comes from two sources: momentum, from the exit velocity, and buoyancy, from the temperature difference between the gas and the surrounding air. Cooling the gas removes the buoyant component and so reduces the rise - which is why heat recovery from a stack has to be weighed against the dispersion it costs. A lower wind speed helps because a strong wind bends the plume over before it can climb.
Please log in or register to report this question.
Which statement about the distance to the maximum ground level concentration is FALSE?
Answer: A
Correct answer: It decreases as the stack gets taller
That is the false one. A taller stack - or a greater effective height once plume rise is added - moves the point of maximum ground level concentration *further* downwind, because the plume must spread through a greater depth before it reaches the ground. The other three are correct: stability slows the spreading and pushes the maximum further out, so in stable air it may lie several kilometres away.
Please log in or register to report this question.
Which of these is LEAST relevant to sizing a stack?
Answer: B
Correct answer: The pollutant's molecular formula
Dispersion is a physical process, and the equations contain the emission rate, the effective stack height, the wind speed and the atmospheric stability - not the identity of the molecule. The chemical formula matters for the concentration limit that must be met and for any reaction in the plume, but not for the sizing of the stack itself. Building heights, gas volume and design wind speed all enter directly.
Please log in or register to report this question.
Which statement about building downwash is TRUE?
Answer: C
Correct answer: A plume in the wake cavity reaches the ground
A building disturbs the flow around it and creates a recirculating cavity in its lee. A plume drawn into that cavity is mixed to the ground immediately, so the whole benefit of the stack is lost. The remedies work the other way from the option offered: *raising* the exit velocity and building the stack to about two and a half times the height of the nearby structure keep the plume clear of the wake.
Please log in or register to report this question.
