Discussion
What does the alternating load line's slope depend on?
Answer: A
The signal sees the collector resistor in parallel with any coupled load, and any bypassed emitter resistor as a short, so that combination sets the slope. The supply and total resistance define the direct load line, and the quiescent current locates the pivot rather than the slope. The device's output resistance is usually far higher and negligible. Two load lines with different slopes through one point is the standard picture, and knowing which resistances belong to each is the whole of drawing it.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development