Discussion
Which of the following is abrasive machining process
Answer: D
The answer is All of the above.
Each of these removes metal with hard abrasive grains rather than a defined cutting edge. Grinding uses a rotating bonded abrasive wheel. Honing uses bonded abrasive stones that rotate and reciprocate in a bore to correct its geometry and finish. Lapping uses loose fine abrasive in a paste between the work and a lap to produce very flat or very fine surfaces.
Since all three are abrasive processes, picking only one of them is incomplete.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development