Discussion
To enable OSPFv3, which of the following would you use?
Answer: A
Correct answer: Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
OSPFv3 is enabled per interface, giving the process ID and the area in one command, so the prompt must be interface configuration mode. It differs from OSPFv2, which is configured under the routing process with network statements - in version 3 the interface command replaces them entirely.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development