Discussion
To enable EIGRP, which of the following would you use?
1.Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2.Router1(config-if)# ipv6 router rip 1
3.Router1(config)# ipv6 router eigrp 10
4.Router1(config-rtr)# no shutdown
5.Router1(config-if)# ipv6 eigrp 10
Answer: B
Correct answer: 3, 4 and 5
EIGRPv6 needs three things, unlike the other two protocols. The process is created in global configuration mode with ipv6 router eigrp 10; it starts up shut down, so no shutdown must be entered under the router prompt; and each participating interface is enabled with ipv6 eigrp 10. Omitting the no shutdown is the classic reason an otherwise correct EIGRPv6 configuration forms no adjacency.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development