Discussion
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
Answer: C
Correct answer: You must use the terminal monitor command.
Debug output is sent to the console by default. Over a Telnet or SSH session nothing appears until terminal monitor is issued, which mirrors console messages to that VTY line. The setting applies to the session only, so it must be repeated each time - and debugging over a remote session should be used with care, since heavy output can consume the router’s CPU.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development