Discussion
A body that is too stiff for extrusion is usually corrected by
Answer: A
Correct answer: increasing the water content slightly
Water is what makes the body plastic, so a stiff body wants a little more of it. Raising the pressure instead forces a body that will not flow properly and produces laminations and die wear, and a smaller die makes the problem worse rather than better.
No comment is present. Be the first to comment.
Loading…
Post your comment
Please log in or register to post a comment.
Examination Categories
- SSC Exams
- Banking Exams
- Teaching Exams
- Civil Services Exams
- Railways Exams
- Engineering Recruitment Exams
- Defence Exams
- State Government Exams
- Police Exams
- Insurance Exams
- Nursing Exams
- Other Government Exams
- NRA CET
- PG Entrance Exams
- Campus Placement
- MBA Entrance Exams
- CUET and UG Entrance
- Judiciary Exams
- Regulatory Body Exams
- Software Development