Machine-translated by Google. Questions are authored in English.
Top

MH SET 2011: 27 November, Paper II, Electronic Science

  • Date: 27 November 2011
  • Paper code: 27NOV_ELECTRONIC_SCIENCE_PII
  • Language: Bilingual
  • 8 pages
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 1 of 8
Page 1 of 8
Text of page 1
NOV-38211/II
                         ELECTRONIC SCIENCE
                                      Paper II
Time Allowed : 75 Minutes]                          [Maximum Marks : 100
Note : This Paper contains Fifty (50) multiple choice questions, each question
       carrying Two (2) marks. Attempt All questions.



1.   For a certain 12 V zener diode, a            3.   The process of growth, by which an
     10 mA change in zener current
                                                       amount of material is set down upon
     produces a 0.1 V change in zener
     voltage. The zener impedance for                  a crystalline substrate while the
     this current, change is :                         overall single-crystal structure is
     (A) 0.1 ohm
                                                       still preserved, is known as............ .
     (B) 1    ohm
     (C) 10   ohm                                      (A) Impurity diffusion
     (D) 100 ohm
2.   Which of the following statements                 (B) Doping
     is correct :
                                                       (C) Epitaxy
     (A) more number of electron-hole
         pairs will be generated in silicon            (D) Ion implantation
         than in germanium at room
         temperature                              4.   A major factor that limits the high
     (B) less number of electron-hole
                                                       frequency gain of MOS transistors
         pairs will be generated in silicon
         than germanium at room                        is...................caused by overlapping of
         temperature                                   the gate electrode and the drain.
     (C) number of electron-hole pairs
         generated are equal both in                   (A) Overall impedance
         silicon and germanium at room
         temperature                                   (B) Parasitic capacitance
     (D) Conductivity of silicon is more
                                                       (C) Parasitic conductance
         than that of germanium at
         room temperature                              (D) Overall conductance

                                              1                                            [P.T.O.
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 2 of 8
Page 2 of 8
Text of page 2
NOV-38211/II

5.   Metallization in IC fabrication is
                                                 7.   Laplace transform of first derivative
     carried by :
                                                      of a function f(t) is :
     (A) CVD technique
                                                            F(S)
     (B) EB evaporation technique                     (A)
                                                             S

     (C) ALD technique
                                                      (B) S F (S)  f (0)

     (D) Oxidation technique
                                                      (C) F (S)  f (0)
6.   A circuit consists of two resistances

     R1 and R2 in parallel. The total                 (D) S F (S)  S f (0)

     current passing through the circuit
                                                 8.   Z-transform of x(n) = G (n – k) for
     is I T , then the current passing

     through R1 is :                                  k > 0 is :

            R1
     (A) R + R I T                                    (A) Z K
          1    2


           R1 + R 2
     (B)            IT
             R1                                       (B) 1

            R2
     (C) R + R I T
          1    2                                      (C) Z–K

             IT
     (D) R [R + R ]
          1  1   2                                    (D) K

                                             2
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 3 of 8
Page 3 of 8
Text of page 3
NOV-38211/II

                                                10. What is the driving-point impedance
9.   One of the following properties of

                                                       of the following circuit (consider
     transfer function is correct :
                                                       1-1 port as input) ?

     (A) The transfer function is not a            1                                  2
                                                               1              2:

         ratio of polynomials in S                                     3:

                                                   1                                  2
     (B) All complex poles and zeros
                                                       (A) 3 :

         must not occur in conjugate
                                                       (B) 5 :

         pairs                                         (C) 4 :

                                                       (D) 2.2 :
     (C) The real parts of all poles must

                                                11. The average value of a half wave
         be positive
                                                       rectifier voltage with a peak value

     (D) The coefficients of numerator                 of 200 V is :

                                                       (A) 63.7 V
         polynomial        P(S)       and
                                                       (B) 127.3 V
         denominator polynomial Q(S)
                                                       (C) 141 V
         must be real
                                                       (D) 0 V

                                            3                                       [P.T.O.
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 4 of 8
Page 4 of 8
Text of page 4
NOV-38211/II

12. A DC voltage regulated power               14. For an inverting amplifier, the input

                                                   is fed through a resistance R1 and
    supply normally uses :
                                                   let R2 be the feedback resistance.
    (A) only amplifier circuit
                                                   Then the input resistance is

    (B) only negative feedback                     approximately :


    (C) amplifier and error feed-                  (A) R12 / R 2


         back                                      (B) R 22 / R1


                                                   (C)    R1R 2
    (D) only filter circuit

                                                   (D) R 1
13. Two inputs sin Zt and cos Zt are fed

                                               15. If A is the amplifier gain and B is
    to two terminals of a differential
                                                   the feedback factor, then condition
    amplifier. The output will be :
                                                   for generating oscillations is :

    (A) sin Zt + cos Zt
                                                   (A) AB = –1

    (B) sin Zt – cos Zt                            (B) AB = +1


    (C) 0                                          (C) AB = 0


    (D) sin Zt . cos Zt                            (D) AB = f


                                           4
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 5 of 8
Page 5 of 8
Text of page 5
NOV-38211/II

                                                 19. A modulus 5 ring counter requires
16. The   most       suitable   gate   for
                                                     a minimum of :
    comparing two bits is :
                                                     (A) ten flip-flops
    (A) AND
                                                     (B) five flip-flops
    (B) OR
                                                     (C) four flip-flops
    (C) NAND
                                                     (D) twleve flip-flops

    (D) XOR                                      20. A memory with 256 addresses

17. On a Karnaugh map, grouping the                  has :

    0’s produces :                                   (A) 256 address lines

    (A) a product of sums expression                 (B) 6 address lines


    (B) a sum of products expression                 (C) 1 address line

                                                     (D) 8 address lines
    (C) a “don’t care” condition
                                                 21. Which of the following is an example
    (D) AND-OR logic
                                                     of embedded system for data
18. A 4-bit parallel adder can add :                 communication ?

    (A) two 4-bit binary numbers                     (A) USB for mass storage

    (B) two 2-bit binary numbers                     (B) Digital camera

    (C) four bits at a time                          (C) Network router


    (D) four bits in a sequence                      (D) Music player


                                             5                                     [P.T.O.
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 6 of 8
Page 6 of 8
Text of page 6
NOV-38211/II

22. What is the minimum number of           24. The serial port of the standard 8051

   I/O lines required to interface a            architecture is :

   16 key matrix keyboard ?
                                                (A) Simplex

   (A) 16
                                                (B) Half duplex

   (B) 8
                                                (C) ‘Receive’ buffered

   (C) 32
                                                (D) ‘Transmit’ buffered

   (D) 4
                                            25. Which is the addressing mode for
23. What is the minimum number of
                                                the    instruction       MOVC    A,
   interface   lines   required   for
                                                @ A + DPTR ?
   implementing I2C interface ?

                                                (A) Direct
   (A) 2

                                                (B) Indexed
   (B) 1

                                                (C) Immediate
   (C) 3

                                                (D) Register
   (D) 4

                                        6
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 7 of 8
Page 7 of 8
Text of page 7
NOV-38211/II

26. What will be the output of the
                                         27. The resolution of a SVGA monitor

    following C program module ?
                                             is :

    main( )
                                             (A) 320 × 200

    {   int i, j;
                                             (B) 320 × 400
        i = 0;
                                             (C) 640 × 640
        do

                                             (D) 640 × 480
        {     j = i * i;

                                         28. The data structure which allows
        i++;

                                             storage of multiple values in the
        }     while (j < = 6);

                                             same variable name with a subscript
        print (“%d %d”, i, j);

                                             is called as :
    }

                                             (A) Array
    (A) 2      4


    (B) 3      4                             (B) Tree


    (C) 4      9                             (C) List


    (D) 4      4                             (D) Que

                                     7                                   [P.T.O.
MH SET 2011 question paper, 27 November 2011, Paper II, Electronic Science, page 8 of 8
Page 8 of 8
Text of page 8
NOV-38211/II

29. Which of the following is not a serial       31. A transmission line has a VSWR of

                                                     2, The reflection coefficient is :
     port ?
                                                           1
                                                     (A)
     (A) USB                                               3

                                                     (B) 0
     (B) Centronix port
                                                           1
                                                     (C)
     (C) RS232 C                                           4

                                                           1
     (D) 9 pin D connector on a PC                   (D)
                                                           2

         motherboard                             32. A strip transmission line is formed

                                                     over a dielectric medium with
30. The correct sequence for file
                                                     r    4 . The width of the strip is
     handling in C is :
                                                     6 mm and the thickness of dielectric

     (A) Define file pointer, use fopen,             is 2 mm. The characteristic

                                                     impedance of this line is :
         read/write data, close
                                                         1          P0
     (B) Use fopen, define file pointer,             (A) 20
                                                                    0

         read/write data, close
                                                               P0
                                                     (B)
                                                               0
     (C) Use fopen, close, define file
                                                           P0
         pointer, read/write data                    (C) 2 
                                                            0

     (D) Define file pointer, read/write
                                                            1       P0
                                                     (D)
         data use fopen, close                             10       0


                                             8
Page 1 of 8

Source: Savitribai Phule Pune University. Question paper published by Savitribai Phule Pune University.