Machine-translated by Google. Questions are authored in English.
Top

Storage Engineering Questions and Answers

31.

Respiration roughly doubles for every \( 10 \) degree rise. Cooling produce from \( 30 \) to \( 10 \) degrees reduces the rate by a factor of about

Answer: C

Correct answer: 4

Respiration doubles for each ten degree rise, so cooling by twenty degrees is two halvings:

\[ \frac{r_{30}}{r_{10}} = 2^{(30-10)/10} = 2^2 = 4 \]

The distractor \( 2 \) accounts for only one ten-degree step, and \( 8 \) would correspond to a thirty degree drop. This exponential dependence is the whole justification for precooling and the cold chain: a fourfold reduction in metabolic rate translates directly into a several-fold extension of storage life.

Please log in or register to report this question.

32.

A fumigation requires \( 2 \) g of phosphine per cubic metre in a structure of \( 480 \) m\(^3\). The quantity needed is

Answer: D

Correct answer: 960 g

Multiply the required dosage by the volume to be treated:

\[ m = 2\ \mathrm{g/m^3} \times 480\ \mathrm{m^3} = 960\ \mathrm{g} \]

The volume is the whole enclosed space, not just the grain, since the gas must fill it. And the dosage is only half the requirement: the structure must be sealed well enough to hold that concentration for the full exposure period, typically several days for phosphine, or the surviving insects will include the resistant ones.

Please log in or register to report this question.

33.

Grain at \( 13 \) per cent moisture and \( 30 \) degrees has a safe storage life of \( 120 \) days. If cooling to \( 20 \) degrees doubles it, the new life is

Answer: A

Correct answer: 240 days

Doubling the storage life gives

\[ 120 \times 2 = 240\ \mathrm{days} \]

The underlying reason is that the processes limiting storage life - respiration, mould growth and insect development - all slow markedly with temperature, so a ten degree reduction typically doubles the safe period. The same relation compounds: cooling to 10 degrees would extend it further again, which is why aeration to cool a bulk is among the cheapest interventions available.

Please log in or register to report this question.

34.

A cold store's total load is product \( 37 \) kW, respiration \( 1.8 \) kW, transmission \( 1.4 \) kW and infiltration \( 2.6 \) kW. With a \( 15 \) per cent safety margin the plant should be rated at

Answer: B

The four loads sum to \( 42.8 \) kW, and adding fifteen per cent gives \( 49.2 \) kW as the duty to specify. Omitting the respiration and infiltration terms is much the commonest way such plants end up undersized in service.

Please log in or register to report this question.

35.

Statement I: Aeration of a grain store dries the grain to a safe moisture.

Statement II: Aeration air flows are of the order of a tenth of a cubic metre per minute per tonne.

In the light of the above statements, choose the correct answer.

Answer: C

Correct answer: Statement I is incorrect but Statement II is correct

Statement I is incorrect. Aeration does not dry grain; it cools it and evens out the bulk. Grain must already be at a safe moisture before it is stored, because aeration cannot correct grain put away too wet.

Statement II is correct and is precisely why. At \( 0.1 \) cubic metres per minute per tonne, the air flow is one to two orders of magnitude below what a dryer uses - enough to move a cooling front slowly through the bulk, but nowhere near enough to carry away significant moisture.

Please log in or register to report this question.

36.

Statement I: Cooling a grain bulk suppresses insect activity.

Statement II: Most storage insects breed rapidly between 25 and 33 degrees and almost stop below 15.

In the light of the above statements, choose the correct answer.

Answer: D

Correct answer: Both Statement I and Statement II are correct

Both statements are correct and the second explains the first. Storage insects breed rapidly in the 25 to 33 degree range typical of an unaerated tropical store, and their development slows sharply below about 15 degrees.

Cooling the bulk by aeration therefore controls infestation directly, without chemicals and without residues, and it simultaneously slows mould growth and respiration. Where night air is cool enough to be useful, this is among the cheapest and most durable protections available.

Please log in or register to report this question.

37.

Statement I: Moisture migration in a silo is caused by convection currents within the bulk.

Statement II: Air warmed at the centre rises and deposits moisture where it meets the cold roof.

In the light of the above statements, choose the correct answer.

Answer: A

Correct answer: Both Statement I and Statement II are correct

Both statements are correct and the second describes the mechanism. Temperature differences within a stored bulk drive slow convection currents in the interstitial air. In a warm store cooling from outside, air warmed near the centre rises, carrying moisture with it, and on reaching the cold underside of the roof it is cooled below its dew point and deposits that moisture.

The result is a wet layer at the grain surface where moulds and insects establish, even though the bulk average moisture is unchanged. Aeration counters it by removing the temperature gradients that drive the circulation.

Please log in or register to report this question.

38.

Statement I: Hermetic storage works by keeping the grain very dry.

Statement II: In a sealed structure respiration depletes the oxygen and raises the carbon dioxide.

In the light of the above statements, choose the correct answer.

Answer: B

Correct answer: Statement I is incorrect but Statement II is correct

Statement I is incorrect. Hermetic storage does not work by keeping the grain dry - the grain must still be dry enough to store, but that is not the mechanism.

Statement II is correct and gives the actual principle: in a sealed structure the respiration of the grain, insects and moulds consumes the oxygen and raises the carbon dioxide, and the resulting atmosphere kills the insects and suppresses the moulds. The infestation destroys its own environment. The requirement is therefore an airtight seal, and any leak that admits fresh air defeats it.

Please log in or register to report this question.

39.

Statement I: Respiration heat can be neglected when sizing a cold store.

Statement II: Respiration rate roughly doubles for every ten degree rise in temperature.

In the light of the above statements, choose the correct answer.

Answer: C

Correct answer: Statement I is incorrect but Statement II is correct

Statement I is incorrect. Respiration heat cannot be neglected - 40 tonnes of produce respiring at \( 45 \) mW/kg generates \( 1.8 \) kW continuously, comparable with the transmission load of a well-insulated room and, unlike the product load, present for the whole storage period.

Statement II is correct: respiration roughly doubles for every ten degree rise. That relation is exactly why the load must be included and why it should be evaluated at the warmest temperature the produce will occupy, which is during pull-down rather than at the final storage temperature.

Please log in or register to report this question.

40.

Statement I: A metal silo is more prone to moisture migration than a concrete one.

Statement II: Thin steel follows the outside temperature closely, so the bulk sees larger swings.

In the light of the above statements, choose the correct answer.

Answer: D

Correct answer: Both Statement I and Statement II are correct

Both statements are correct and the second explains the first. A thin steel wall has little thermal mass and follows the ambient temperature closely, so the grain adjacent to it swings with the day and the season while the core of the bulk lags far behind.

Those steep and changing gradients drive the convection currents that carry moisture from warm regions to cold surfaces, where it condenses. A concrete silo's thermal mass damps the swings and so reduces the driving force. Metal silos are cheap and quick to erect, which is why they are common despite needing more careful aeration.

Please log in or register to report this question.

Loading…
Tags: Storage Engineering Questions and Answers || Storage Engineering MCQ Questions and Answers || Storage Engineering GK Questions and Answers || Storage Engineering GK MCQ Questions || Storage Engineering Multiple Choice Questions and Answers || Storage Engineering GK || GK on Storage Engineering || Agricultural Process Engineering Questions and Answers || Agricultural Process Engineering MCQ Questions and Answers || Agricultural Process Engineering GK Questions and Answers || GK on Agricultural Process Engineering