In a series arrangement of two dielectrics between capacitor plates, the larger field appears in the layer of
Answer: D
The normal flux density is common to both layers, so the field intensity is inversely proportional to the permittivity. A thin air gap inside solid insulation therefore carries a much higher field than the solid, which is why voids are the usual starting point of failure.
Please log in or register to report this question.
A parallel plate capacitor of area 0.01 m² and gap 1 mm in air has a capacitance of about
Answer: A
Correct answer: 88.5 pF
\[ C = \frac{\epsilon_0 A}{d} = \frac{8.854\times10^{-12} \times 0.01}{0.001} = 8.85\times10^{-11}\ \mathrm{F} = 88.5\ \mathrm{pF}. \] The figure is worth remembering as a scale: a hundred square centimetres a millimetre apart gives well under a nanofarad, which is why practical capacitors use very thin dielectrics and very large rolled or stacked areas.
Please log in or register to report this question.
Filling that same capacitor with a dielectric of relative permittivity 4 raises its capacitance to
Answer: B
The capacitance is multiplied by the relative permittivity, so \( 4 \times 88.5 = 354 \) pF. The stored energy at a given voltage rises by the same factor, which is why high permittivity ceramics are used where compactness matters.
Please log in or register to report this question.
Two capacitors of 3 \( \mu \)F and 6 \( \mu \)F in series give a combined capacitance of
Answer: C
Correct answer: 2 \( \mu \)F
In series the reciprocals add: \[ \frac{1}{C} = \frac{1}{3}+\frac{1}{6} = \frac{1}{2}, \qquad C = 2\ \mu\mathrm{F}. \] The result is smaller than either capacitor, which is the check to apply - series capacitance behaves like parallel resistance, and adding them directly gives the 9 offered.
Please log in or register to report this question.
Those same two capacitors in series carry 12 V across the pair. The voltage across the 3 \( \mu \)F capacitor is
Answer: D
The same charge sits on both, so the voltages divide in inverse proportion to the capacitances and the smaller capacitor takes the larger share, two thirds of twelve volts. This is the opposite of how a series resistive divider behaves with respect to resistance.
Please log in or register to report this question.
A coaxial cable with inner radius 1 mm and outer radius 3 mm, filled with a dielectric of relative permittivity 2.5, has a capacitance per metre of about
Answer: A
Correct answer: 127 pF
For a coaxial line, \[ C = \frac{2\pi\epsilon_0\epsilon_r}{\ln(b/a)} = \frac{2\pi \times 8.854\times10^{-12} \times 2.5}{\ln 3} = \frac{1.391\times10^{-10}}{1.0986} = 127\ \mathrm{pF/m}. \] The logarithm makes the capacitance insensitive to the exact radii - tripling the ratio again would change it by only a third - while the permittivity multiplies it directly.
Please log in or register to report this question.
A capacitor of 10 \( \mu \)F is charged to 100 V. The energy stored is
Answer: B
Correct answer: 50 mJ
\[ W = \tfrac{1}{2}CV^{2} = \tfrac{1}{2} \times 10\times10^{-6} \times 100^{2} = \tfrac{1}{2} \times 10^{-5} \times 10^{4} = 0.05\ \mathrm{J} = 50\ \mathrm{mJ}. \] Omitting the factor of one half gives the 100 mJ offered. Note that the energy goes as the square of the voltage, so doubling the voltage quadruples the stored energy.
Please log in or register to report this question.
The charge on that same 10 \( \mu \)F capacitor at 100 V is
Answer: C
Multiplying gives \( 10^{-5} \times 100 = 10^{-3} \) coulombs. A millicoulomb is an enormous charge by electrostatic standards, which is why capacitor voltages of a hundred volts are ordinary while a charged sphere at a hundred volts holds almost nothing.
Please log in or register to report this question.
Two dielectric layers of equal thickness and relative permittivities 2 and 4 fill a capacitor gap in series. The ratio of the fields in them is
Answer: D
The normal flux density is the same in both, so the field intensity is inversely proportional to the permittivity and is twice as large in the layer of permittivity two. That is where breakdown would begin, other things being equal.
Please log in or register to report this question.
A 1 mm air gap lies in series with 4 mm of solid insulation of relative permittivity 4, across 1000 V. The field in the air gap is about
Answer: A
The equivalent electrical thickness of the solid is one millimetre, so the two layers behave as equal capacitances and share the voltage equally: 500 V across one millimetre of air, that is 500 kV/m. Air breaks down at about 3 MV/m, so this gap survives.
Please log in or register to report this question.
